STAW

Hone Width

If an insert with honing other than standard is needed, please order using the symbols below.

Insert Order Number
Honing Standard

Notes On Use

Insert Installation

INSERT INSTALLATION

1. Before inserting the insert into the holder, ensure that there are no foreign objects or dirt in the holder slot or slit. If there are any foreign objects or dirt, use compressed air to remove them.

figure 1

2. Use the provided wrench to loosen the inner screw to open the tip of the holder, then put the insert into the holder slot as shown in figure 1
*Ensure that the wrench is firmly in contact with the base of the inner screw head when tightening.

figure 2

3. After the insert has been set in the holder slot, tighten the inner screw while holding the insert lightly as shown in figure 2 to securely clamp and locate the insert.
*Ensure that the wrench is firmly in contact with the base of the inner screw head when tightening.

Tighten the clamp screw according to the torque below.

Tighten the clamp screw according to the torque


4.Check there is no gap between the bottom of the insert and holder slot.

Check there is no gap

(Note) Poor or incorrect clamping of inserts can cause poor drilling performance and/or drill breakage.
Therefore ensure that the alignment marks on both the body and insert are aligned when setting.
When machining, use safety guards and goggles.

Spare Parts

内ねじ・ストッパー部品表

(Note) The parts are packaged internal screw, stopper and operation manual. Please replace the parts in accordance with the operation manual.

Page Top