WJX

OPERATIONAL GUIDANCE

Depth of Cut

The straight cutting edge is 2.0mm at maximum depth of cut (APMX).
When plane cutting steels and cast irons, the depth of cut can be set at up to 3.0mm until you reach the corner radius.
When you exceed 2.0mm, you will need to decrease the feed rate. See the cutting conditions on page M177 for reference.

tec_milling_precautions_wjx_01_en-gl.png

Remaining Stock

When using the WJX, please program as a radius cutter.
The approximate remaining stock K for the program is shown below.
Also see the table on the right for the remaining stock H of the vertical wall.

tec_milling_precautions_wjx_02_en-gl.png
Page Top