iMX holder application

•Combination of the straight type and standard head causes interference when the depth of cut is head length or more. (Because holder diameter = head diameter)

•Combination of the straight type and offset head may make the depth of cutting length or more. (Because holder diameter < head diameter)

Straight + Standard Head

Straight + Standard head

Installation at an overhang of DC×3 or less is also possible,if the depth of cut < head length is assumed.

Straight + Offset Head

Straight + Offset head

•It is suitable for vertical wall machining, because the undercut type has a relief neck.
•A taper neck with thick relief has high rigidity. Especially a stable cutting is demonstrated at deeper machining.
•Perform straight shank additional grinding together with customer application for undercut taper neck type.
(Refer to the cutting edge diameter (DC) of each type for the minimum machining diameter.)

Undercut + Standard Head

Undercut + Standard head

Taper neck + Standard Head

Taper neck + Standard head
Page Top