Hone Width

If an insert with honing other than standard is needed, please order using the symbols below

Insert Order Number)

Notes on Use

Insert Installation

•Loosen the clamp screw to install the insert.
•Correctly mesh the insert and the holder serrations, then slide the insert to the bottom of the slot.
•Fasten the clamp screw using the torque wrench provided while holding the insert lightly as shown. (Figure 1)
•Check there is no gap between the bottom of the insert and holder. (Figure 2)

Tighten the clamp screw according to the torque below.


Insert Replacement

•Thouroughly clean the serrations of the holder before installing a new insert.
Remove heavy dirt in the holder serrations by using the cleaning plate provided.

Page Top