• Improving Surface Finish
Under the same machining conditions as conventional breakers, but with the feed rate increased, the surface finish of the workpiece can be improved.
• Improving Efficiency
High feed rates not only shorten machining times but also make it possible to combine roughing and finishing operations.
• Increased Tool Life
When a change to high feed conditions, the time required to cut one component is decreased, thus more parts can be machined with each insert. In addition, the high feed rate prevents rubbing, therefore, delaying the progression of wear and increasing the tool life of the insert.
• Improving Chip Control
Under high feed conditions, the chips generated become thicker and are more easily broken, thus, chip control is improved.
Wiper insert for low rigidity workpieces
New wiper edge code
NOTES FOR USE
No Restriction for Holders
A standard holders can be used. (*A double clamp, high rigidity tool is recommended.)
Restriction for Holders
Use a holder with end cutting angle 93° for improving wiper efficiency. A holder with end cutting angle 91° can improve wiper efficiency, however, there is no wiper efficiency with other end cutting angles (60°, 90°,107°etc.).