Tool Selection

Notes When Selecting the Tool Body

Precautions When Selecting a Modular Holder.

Precautions when selecting a modular holder.

Select a modular holder with the largest possible shank size to maintain mounting rigidity.

Modular Blade (1)

Modular blade (1)

If there is no restriction for use, select the largest modular blade for the same shank size.

Modular Blade (2)

モジュラーブレード選択の注意点2

Select the shortest possible blade suitable for the application.

Modular Blade (3)

モジュラーブレード選択の注意点3

Select the shortest possible blade suitable for the application.

Notes When Setting the Tool

Setting of Cutting Edge Height

刃先高さの設定

<Grooving/Cross-feed machining>
Set the cutting edge height to ±0.1mm parallel to the central axis.
<Cutting off>
Set the cutting edge height to 0–+0.2mm parallel to the central axis.

Tool Body Setting Angle

本体セット角度

Set the insert perpendicular to the central axis.

Overhang

オーバーハングの注意点

When setting the tool, ensure that the overhang is as short as possible and avoid the step difference part as above figure shows.

Technical Information / Cutting Formula

Introduction

Turning Tools

Rotating Tools

Standards and Information

Page Top