PRECAUTION

Ceramic End Mills

Cutting Conditions

Requires High Cutting Speeds (From 350m/min to 1000m/min)

High speed cutting is required to generate the heat needed to soften materials without causing abrasion or other damage.
Cutting speeds from 350m/min to 1000m/min is recommended.

Recommendation for Air Blow

thermal cracking
Example of thermal cracking

Do not use the coolant, it can cause thermal cracking.
Air blow is not used for the purpose of cooling and should not be directed at the tool. It should be used for good chip evacuation only.

Applications

Recommendations for Continuous Cuttting

Continuous cutting is highly recommended. Damage or chipping can occur during interrupted cutting.

Recommendations for continuous cuttting

Width of Cut is Recommended to Increase Gradually

Using maximum width and depth of cut from the start of machining may cause damage.
Increase the width of cut (ae) gradually to maintain tool life.

Width of cut is recommended to increase gradually.

Method: Down Cut (Climb Milling)

Down cut / climb milling is highly recommended. Up cutting can be unstable.

Method: Down cut (climb milling)

Others

Tool Holder Recommendation - Hydraulic Chuck

First recommendation for tool holding is a hydraulic chuck, second recommendation is a precision milling chuck.
Collet chucks are not suitable.

Tool holder recommendation - Hydraulic chuck

Do not Remove The Built Up Edge

Do not remove any built up edge manually after machining as this may cause chipping.
The built up edge will be removed by the heat generated during the next cutting cycle.

Final Machining Allowance of More Than 0.3mm

Leave a minimum of 0.3mm finishing allowance. Machining with ceramic end mills at high temperatures can affect the outermost layer of the machined material, therefore a final machining allowance must remain.

Do not Use Open Type Machines

The chips generated during machining are at extremely high temperatures.
Ensure the inside of the machine is free from any combustible materials.

Do not use open type machines


Page Top